Page Comparison

Here we will guide you through the configuration of the service consumer. After completing all the steps you should have a working communication channel from a message broker to SAP. However, it is assumed that you are using a message broker installed in Windows or Linux server and if you are using Message Broker in BTP please check thisas there are certain details that must be considered during configuration.

...

7. Press ‘Next’ and continue to ‘Consumer security’ screen where in ‘Authentication Settings’ select ‘User ID / Password’. This is exactly the same user and same password that were defined in the message broker configuration file in the 'WebServiceDefinition' section.
   

   

8. Anchor
   HTTPSettings HTTPSettings

   Press ‘Next’ and continue to HTTP Settings. Here you must define a web service that you intend connecting to what in this case means the message broker. Start with selecting between ‘Complete URL’ and ‘URL components'. For those who are not particularly familiar with these kind of things we recommend to choose ‘URL Components’ - this should make providing valid information much easier however complete URL follows this simple pattern: [protocol]://[host]:[port][path]
   

   In the HTTPSettings view of SOA Manager there three main sections:

   • URL Access Path - here, as mentioned above, you must provide information on how to locate a message broker and interesting service.

     • Protocol - here you decide if you are using secure HTTPS connection or regular HTTP. Your selection must corresponding to what has been defined in message broker configuration - if HTTPS is enabled or not

     • Host- this is simply an address of a server where your message broker was installed. This can be IP address or domain name. And this is something you have to know.

     • Port - This is the same port number that is defined in the message broker configuration file

     • Path - Like above, but it is the UrlPath from the message broker configuration file which must be copied here

7. Proxy - this part, most likely, you should leave empty unless there is a proxy between your SAP system and message broker server although this could impact communication in the opposite direction.

   • Transport Binding - following values must be set. Usually there are default values and they are already set:

     • Make Local Call - No Call in Local System

     • Transport Binding Type - SOAP 1.1

     • Maximum Wait for WS Consumer - 0

     • Optimized XML Transfer - None

     • Compress HTTP Message - Inactive

     • Compress Response - True

8. Press ‘Next’ and continue to SOAP Protocol view - here following values must be set and unlike the ‘Transport Binding’ these are not default ones:

   • Message ID Protocol - Suppress ID Transfer

   • Data transfer scope - Minimal Data Transfer

   • Transfer protocol - Transfer via HTTP header

   • Process Attachments - No

9. Press ‘Finish’ and job’s done. Now you should be redirected to a view showing the list of created logical ports. Make sure that the ‘State’ of the newly created port is Active - if not, please do select it and 'Activate'

...