...
Install SAP FSM S/4HANA CONNECTOR 3.0 (S4PACG 300)
In the systems where SAP Note 3472266 is in place or one of the following service packs SAPK-10704INS4CEXT or SAPK-10802INS4CEXT is installed, the FSM Connector Add-On must be installed together with Service Pack 1. Also, before note installation or upgrade of component S4CEXT the Connector must be upgraded at least to SP01
Install relevant SAP notes (the list of release SAP notes is available here)
Follow the steps described in Proaxia FSM Connector setup
...
FSM Connector upgrade to S4PACG 300 is only possible from S4PACG 200 - for details check 2918834 - Release strategy for ABAP add-on S4PACG
The S4PACG 300 contains all the functionalities delivered by the S4PACG 200 SP 13 plus the additional features described below
The post-installation steps depend on the initial version of the Connector which was upgraded. FSM Connector 3.0 is fully backwards compatible and does not require any extra actions upon installation, however, it is recommended to check post-installation steps for each Connector’s Service Pack that was released after the release of Connector which is subject of the upgrade to S4PACG 3.0 and the S4PACG 3.0 it self. For example, if you are upgrading S4PACG 2.0 SP 10 to S4PACG 3.0 you should check post-installation steps for S4PACG 2.0 SP 11, 12 and 13.
Run the /PACG/ECM_SETUP report
| Anchor | ||||
|---|---|---|---|---|
|
...