Post-installation steps for UPGRADE TO (S4)PACG 200
STEPS THAT MUST BE PERFORMED AFTER UPGRADING TO THE NEW ADD-ON PACG200/S4PACG200
Run the Setup program - it will configure new objects which are introduced in the new Connector version (Besides this step need to be done no matter if you are upgrading or installing FSM Connector for the first time)
If you are upgrading from version other than PACG110 SP03/S4PACG SP03 then you should migrate FSM Users
Run migration report https://proaxia-prod-doc.atlassian.net/wiki/spaces/PFCC/pages/514424880
In the https://proaxia-prod-doc.atlassian.net/wiki/spaces/PFCC/pages/31952767 change setting for message /PACG/ECM_PERSONIN and set inbound data handling class to /PACG/ECM_CL_S_IDOC_I_USER1
In the /PACG/ECM_CLSASSIG - E4C Outgoing Messages Configuration change setting for message /PACG/ECM_USER and set data selection class to /PACG/ECM_CL_S_SEL_USER1
If you are upgrading from any older version and you use attachments then following steps needs to be performed
In the https://proaxia-prod-doc.atlassian.net/wiki/spaces/PFCC/pages/31952767 change setting for messages /PACG/ECM_ATTCHMIN and /PACG/ECM_SIGNATURE and set inbound data handling class to /PACG/ECM_CL_S_IDOC_I_ATTCHM2
In the /PACG/ECM_CLSASSIG - E4C Outgoing Messages Configuration change setting for message /PACG/ECM_ATTCHMOUT and set IDOC creation class to /PACG/ECM_CL_S_IDOC_O_ATTCHM2
If you already use DMS attachments in FSM Connector then you should run migration report (in transaction SE38/SA38). Because in case of attachments of type DMS we were forced to change the way in which objects' key are constructed so now for already existing attachment the old keys need to be replaced with now ones in order to avoid duplications.
Get familiar with and set up new customising for attachments. Already existing customising for DMS attachments and/or BDS attachments cannot be transferred automatically and this step must be performed manually if needed. For more details check documentation
Check SAP NOTES already released for your FSM Connector version:
When installing a few service packs one by one, make sure that each service pack’s post-installation steps have been performed. Pay special attention to updating processing classes and transformations. The list of the most up-to-date classes/transformations can be found on the following page:
If you'd like to help us improve the documentation, please provide your feedback using the communication channels listed /wiki/spaces/PFCC/pages/1561427969. Learn about support possibilities here.