FSM Connector is a communication layer between SAP systems and FSM Cloud. As described in FSM Architecture Overview, FSM Connector is composed of two major components: Data Processor and Message Broker. This document is a manual for administrators, describing steps necessary to install and configure FSM Message Broker.
| Info |
|---|
Please note, that due to different architecture, authorizations and skills required to install E4C Data Processor component, its installation has been described in a separate document. Where it is necessary to understand the architecture of Message Broker, in order to be able to set it up correctly, this document describes building blocks of Message Broker (very low level sometimes). It is however not intention of this document to give the reader overall knowledge of what E4C is and how it works. If you need this kind of introduction, please refer toCustomizing Guide.
| Note |
|---|
Network encryption and the (lack of) maintenance of certificates and algorithms to do those can cause connectivity issues. Note that especially root certification authorities should be updated regularly. In case of connection issues to FSM Cloud due to untrusted TLS certificate please refer to the following SAP note: https://launchpad.support.sap.com/#/notes/2943007. |
| Note |
|---|
Do not restart Message Broker during the initial load.Message Broker 2.0 is only available for Windows. To check system requirements go to Message Broker 2.0 for Windows |
Table of contents
| Page Tree |
|---|
| root | [WINDOWS Message Broker 2.0 ] Message Broker Installation and Configuration Guide |
|---|
|
...