...
How to enable the parallel mode for initial and full-sync
Ensure that the SAP FSM company setting ‘TransporterSettings.MaxParallelUploadBatches’ has a correct value
...
set.
Valid Values:
0 - 5 (5 recommended for parallel batches)
Default Value:
0 - the upload is stopped (on hold)
1 -
...
n - the maximum parallel upload batches is n
...
Performance improvement example
Test results of full-sync process for around 55 000 objects (Equipment and Address):
...
No. of threads
...
Duration
...
Speed up factor
...
1
...
18 min. 42 seconds
...
Regular speed
...
5
...
06 min. 09 seconds
...
3x
...
10
...
03 min. 49 seconds
...
5x
...
20
...
03 min. 32 seconds
...
‘original’ behaviour, single upload process
| Note |
|---|
After the initial load, please revert to '1'! Otherwise, there will be a permanent few minutes delay in planning board update. |
| Info |
|---|
The setting is considered only for full sync triggered from FSM Admin or with the program /PACG/ECM_FULLSYNC_S - Fullsync simulate. Other forms of mass data transfer are not supported. |