Versions Compared

Old Version 9

changes.mady.by.user proaxia

Saved on

compared with

New Version Current

changes.mady.by.user proaxia

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Ensure that the SAP FSM company setting ‘TransporterSettings.MaxParallelUploadBatches’ has a correct value higher than 1. set.

  • Valid Values:

    • 0 - 5 (5 recommended for parallel batches)

  • Default Value:

    • 0 - the upload is stopped (on hold)

    • 1 -

    the parallel upload is disabled, the batches are uploaded sequentially (default value)

  • n - the maximum parallel upload batches is n

...

    • ‘original’ behaviour, single upload process

Note

After the initial load, please revert to '1'! Otherwise, there will be a permanent few minutes delay in planning board update.

Info

The setting is considered only for full sync triggered from FSM Admin or with the program /PACG/ECM_FULLSYNC_S - Fullsync simulate. Other forms of mass data transfer are not supported.