Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 6 Next »

Basic prerequisites

Standard SAP setup

Before proceeding, make sure that attachments of a specific storage type (GOS/BDS/DMS) can be manually added in SAP ECC/S4, as described on the following page: Standard SAP attachment setup

FSM Cloud Connector version

The steps described in this document, including the most important transaction - /PACG/ECM_CUST_ATTA - Inbound / Outbound Attachment Configuration - are available for FSM Cloud Connector add-on 200. Due to additional enhancements, it is recommended that the latest available service pack be used. Information about the newest FSM Cloud Connector versions and their release notes can be found on the following page: Releases. Pay close attention to all the attached post-installation steps documents (e.g. UPGRADE TO S4PACG 200 or PACG 200 - post installation steps).

Running the Setup program

After each FSM Cloud Connector update, run the FSM Cloud Connector setup program (/PACG/ECM_SETUP - FSM Connector's Setup). Make sure to include the options below:

Inbound/outbound class assignment

Make sure that in transaction /PACG/ECM_CLSASSIGIN -FSM Connector's Incoming Messages Configuration class /PACG/ECM_CL_S_IDOC_I_ATTCHM2 is set as inbound data creat. class for message /PACG/ECM_ATTCHMIN:

Make sure that in transaction /PACG/ECM_CLSASSIG - E4C Outgoing Messages Configuration class /PACG/ECM_CL_S_IDOC_O_ATTCHM2 is set as IDOC class for message /PACG/ECM_ATTCHMOUT:

FSM Cloud Connector attachment configuration center

Enable attachment sending for specific objects

Attachment inheriting

Obsolete customizing

The following customizing fields and transactions are considered obsolete:

  • No labels

If you'd like to help us improve the documentation, please provide your feedback using the communication channels listed here. Learn about support possibilities here.